Yuku free message boards

Dennis,

It is recommended that you use a high quality shed free 3/8" nap roller sleeve when putting it down and it should not be sprayed. It does have an egg shell finish to it and you need to make sure that you are with in the re-coat window or you will have to sand it before you apply the second coat. If you show a sample to a customer that was only epoxy you had better put some AUS-V on it so they can see the difference because there is. A second coat is not always needed, it will depend on the the type of traffic the floor is going to be under and most importantly how you roll it. Although a second is a better floor. And another note, If you can see roller marks when you roll it out and you leave them there you will be able to see them when it drys. Its not a hard product to roll out but you just need to make sure you are at the coverage rates, don't let it puddle or build up in saw cut or low textured areas and remove your roller marks. If you keep fighting to remove roller marks but you keep leaving more make sure your roller sleeve isn't soaked with material. The best way to prevent that is to use a paint try and just add to it as you need to but if you are putting it down as a satin finish with the aggregate make sure you mix it before you pour more into the tray.